SeaDoo 3D Manual page 303

Section 10 STEERING SYSTEM
Subsection 01 (STEERING SYSTEM)
1. Unbend tab
Pull steering stem no. 27 out.
Remove steering support screws no. 28.
Steering Cable
Remove screws no. 29.
292
1. Screws removed
Remove retaining block no. 30.
Remove ball joint no. 31 and adjustment knob
no. 32 from cable.
Disconnect ball joint no. 33 from jet pump nozzle
then from cable.
Use the steering cable tool (P/N 295 000 145) and
remove nut no. 34, then remove half rings no. 35
and O-ring no. 36.
Raise steering pole.
Cut locking ties as required to allow puling out
steering cable.
Remove steering pole to be able to pull steering
cable out of bilge. See below.
Steering Pole
Raise and lock steering pole with its retainer.
Cut locking ties as required then pull throttle cable
out of steering pole.
Pull wiring harness out of pole.
Completely release return spring no. 2 preload.
www.SeaDooManuals.net
smr2005-066