SeaDoo 3D Manual page 87

Section 03 ENGINE SYSTEM
Subsection 03 (REMOVAL AND INSTALLATION)
REAR ENGINE SUPPORT — 787 RFI ENGINES
1. Torque to 25 N•m (18 lbf•ft)
Final Inspection
Check throttle cable condition and lubricate cable
with Bombardier Lube (P/N 293 600 016).
After its installation, properly adjust and bleed oil
injection pump as specified in OIL INJECTION
PUMP and adjust throttle cable as specified in
CARBURETOR or ENGINE MANAGEMENT (RFI).
Check hose condition and pressure test fuel sys-
tem, refer to FUEL SYSTEM.
WARNING
Whenever doing any type of repair on wa-
tercraft or if any components of the fuel sys-
tem are disconnected, a pressure test must be
done before starting engine.
Verify all electrical connections.
Run engine and ensure there is no leakage.
CAUTION: If watercraft is out of water, engine
must be cooled using the flush kit.
70
www.SeaDooManuals.net
smr2005-049