SeaDoo 3D Manual page 119

1. Fuel filter
2. Inner plastic ring
Regulator
The regulator is not serviceable. Replace the fuel
pump assembly if the regulator is defective.
Fuel Baffle Pick-Up
Carburetor-Equipped Models
NOTE: The baffle pick-up no. 7 has an integrated
fuel sender for the fuel gauge.
F01F20A
1. Pick-up tube
2. Fuel sensor
3. Baffle pick-up
Disconnect BLACK (–) cable, then RED (+) cable
of battery.
smr2005-053
Subsection 02 (FUEL TANK AND FUEL PUMP)
1
2
3
www.SeaDooManuals.net
Section 05 FUEL SYSTEM
WARNING
Always disconnect battery cables exactly in
the specified order, BLACK (–) cable first.
Open storage compartment cover.
Remove rear panel of storage compartment.
Siphon fuel tank no. 6.
Remove steering assembly. Refer to STEERING
SYSTEM for procedure.
Disconnect fuel lines from baffle pick-up and
loosen lower clamp no. 8.
NOTE: Note fuel lines locations for installation.
TYPICAL
1. Disconnect fuel hoses
2. Loosen lower clamp
Disconnect wiring harness of fuel sender.
Remove baffle from fuel tank.
Remove upper clamp no. 9 from adapter no. 10
and slide adapter from baffle.
Push inward on the 3 clips at the base of the baffle
in order to remove the filter no. 11. Pry base off
using a small slotted screwdriver (if necessary).
Electric Fuel Pump
RFI Models
Open the front storage compartment cover (GTI
RFI Series) or remove the engine cover (3D Se-
ries).
Remove the storage basket.
On GTI RFI Series, remove the glove box. For
proper removal procedure, refer to HULL/BODY
section.
103