Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 36

IF THE LIFT TRUCK IS NOT TO BE USED FOR A LONG TIME
INTRODUCTION
The following recommendations are intended to prevent the lift truck from being damaged when it is withdrawn from service
for an extended period.
Procedures to follow if the lift truck is not to be used for a long time and for starting it up again afterwards must be performed by your dealership.
After 12 months, repeat the procedures for putting the lift truck back into service and long-term stoppage.
PREPARING THE LIFT TRUCK
- Clean the lift truck thoroughly.
- Check and repair any fuel, oil, water or air leaks.
- Replace or repair any worn or damaged parts.
- Wash the painted surfaces of the lift truck in clear and cold water and wipe them.
- Touch up the paintwork if necessary.
e
- Stop the lift truck ( OPERATING INSTRUCTIONS UNLADEN AND LADEN).
- Make sure the boom cylinder rods are all in the retracted position.
- Release the pressure in the hydraulic circuits.
DEF (Diesel Exhaust Fluid) TANK
Depending on the model of lift truck
- Drain and rinse the DEF tank.
- Replace the "DEF" (Diesel Exhaust Fluid) supply pump filter (
- Slowly fill the tank with new "DEF" (Diesel Exhaust Fluid) up to the bottom of the filler neck.
- Start up the lift truck to pressurise the circuit and bring it up to working temperature, then shut down the engine.
- If necessary, top up the tank.
PROTECTING THE ENGINE
- Contact your dealer to obtain the procedure for protecting the inside of the engine (use of protection product).
e
- Fill the tank with fuel (
- Drain and replace the coolant (
- Leave the engine running at idling speed for a few minutes, then switch off.
- Replace the engine oil and oil filter (
- Run the engine for a short time so that the oil and cooling liquid circulate inside.
- Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum.
- Block the outlet with waterproof adhesive tape.
- Remove the drive belts and store them in a safe place.
- Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection.
PROTECTING THE LIFT TRUCK
- Set the lift truck on axle stands so that the tyres are off the ground.
- Release the parking brake
- Protect cylinder rods which will not be retracted, from corrosion.
- Wrap the tyres.
NOTE: If the lift truck is to be stored outdoors, cover it with a waterproof tarpaulin.
t
IMPORTANT
This period of long-term stoppage must not exceed 12 months.
3 - MAINTENANCE).
e
3 - MAINTENANCE).
e
3 - MAINTENANCE).
(depending on the model of lift truck).
t
e
3 - MAINTENANCE).
1 - 32
www.duma-rent.com