Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 128

܌ 250H - PERIODIC SERVICE - EVERY 250 HOURS OF SERVICE
CHECK
Park the lift truck on level ground with the boom raised and the engine stopped.
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (
RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
- Pull out dipstick 1.
- Wipe the dipstick and check the correct level between the two MIN and MAX marks.
e
- If necessary, add oil (
- Visually check that there is no leakage or seepage.
CHECK
Place the lift truck on a slope of at least 15% with the rated load in the transport position.
- Check the tightening adjustment by locking the parking brake in position A.
- The adjustment is correct when the lift truck remains stationary on the slope.
- Adjust if necessary.
- Press the brake pedal, then release the parking brake in position B.
- Progressively tighten the end of the lever 1 and recheck braking.
- Repeat the operation until the correct braking adjustment is obtained.
CLEAN
- Since one-way valve 1 is located under the cab, it is possible for it to become
obstructed with spattered mud for example. Clean if necessary.
t t
IMPORTANT
1000H: REPLACE Angle gear box oil).
Angle gear box oil level
e
1 - INSTRUCTIONS AND SAFETY
Parking brake
Heating block check valve
3 - 22
www.duma-rent.com
1
A
1
B
1