Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 145

REPLACE
Operate the battery cut-off for a minimum of 30 seconds after having switched off the ignition with the ignition key.
Handling and servicing a battery can be dangerous, take the following precautions:
- In the event of electrolyte being spilled onto the skin or splashed in the eyes,
rinse thoroughly with cold water for 15 minutes and call a doctor.
- Remove the protective casing 1.
- Bring a backup battery of the same type as that of the lift truck, together with
battery cables.
- Connect the back-up battery, respecting the polarity (-) (+).
- Start the lift truck and remove the cables as soon as the engine is running.
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (
RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
- Change the battery 2.
ADJUST
RECOMMENDED SETTING
(according to standard ECE-76/756 76/761 ECE20)
Adjustment of -2 % of the dipped beam harness relative to the
horizontal axis of the headlight.
ADJUSTMENT PROCEDURE
- Place the unladen lift truck in the transport position
and perpendicular to a white wall on flat, level ground.
- Check the tyre pressures (
- Place the forward/reverse selector in neutral.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (H2)
• h1 = Height of the dipped beam in relation to the ground.
• h2 = Height of the adjusted beam.
• l = Distance between the dipped beam and the white wall.
t t
IMPORTANT
- Wear protective goggles.
- Keep the battery horizontal.
- Never smoke or work near a naked flame.
- Work in a well-ventilated area.
t t
IMPORTANT
Front headlights
e
2 - DESCRIPTION: TYRES).
Battery
e
1 - INSTRUCTIONS AND SAFETY
h2 = h1 - (l x 2 / 100)
+%
-%
h1
h2
3 - 39
www.duma-rent.com
1
2
h1
l