Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 27

TAKING UP A HIGH LOAD ON STABILISERS
- Ensure that the forks will easily pass under the load.
- Check the position of the lift truck with respect to the load and make a test run, if
necessary, without taking the load.
- Raise and extend the boom (1) (2) until the forks are at the level of the load (fig. G5).
- Bring the forks to the stop in front of the load by alternately extending and lowering
the boom (1) (fig. G6).
- Lift the load slightly (1) and tilt the carriage (2) backwards to stabilise the load (fig. G7).
- Monitor the longitudinal stability limiter and warning device (
HANDLING A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE).
If it is overloaded, put the load back down in the place from which it was picked up.
- If possible lower the load without moving the lift truck. Raise the boom (1) to
release the load, retract (2) and lower the boom (3) to put the load into transport
position (fig. F4).
SETTING DOWN A HIGH LOAD ON STABILISERS
- Raise and extend the boom (1) (2) until the load is above the elevation (fig. G9), while
monitoring the longitudinal stability limiter and warning device (
FOR HANDLING A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING
DEVICE).
- Position the load horizontally and release it by lowering and retracting the boom
(1) (2) to position the load correctly (fig. G10).
- Free the forks by alternately retracting and raising the boom (3) (fig. G11).
- If possible, putt the boom in transport position without moving the lift truck.
e
INSTRUCTIONS FOR
G7
2
1
e
INSTRUCTIONS
G10
1
2
1 - 23
www.duma-rent.com
G5
2
1
G6
1
G8
1
2
3
G9
2
1
G11
3