Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 134

Hide thumbs Also See for MT 733 EASY 75D ST5 S1:
Table of Contents

Advertisement

Ü  1000H - PERIODIC SERVICE - EVERY 1,000 HOURS OF SERVICE OR 2 YEARS
CHECK
Under no circumstances must the lift truck be used if the seat belt is defective (fixing, locking, cuts, tears, etc.).
SEAT BELT WITH TWO ANCHORING POINTS
- Check the following points:
• Fixing of the anchoring points on the seat.
• Cleanness of the strap and the locking mechanism.
• Triggering of the locking mechanism.
• Condition of the strap (cuts, curled edges).
REELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points:
• The correct winding of the belt.
• Condition of the reel guards.
• Roller locking mechanism when the strap is given a sharp tug.
NOTE: After an accident, replace the seat belt.
CLEAN
REPLACE
Place the lift truck on level ground with the engine stopped.
While carrying out these operations, do not smoke or work near a flame.
Never try to carry out a weld or any other operation by yourself, this could provoke an explosion or a fire.
- Inspect the parts of the fuel circuit and the tank liable to leak, both visually
and by touch.
- In the event of a leak, contact your dealer.
- Place a container under drain plug 1 and unscrew the plug.
- Remove the filler plug 2 to ensure correct drainage.
- Rinse with ten litres of clean diesel through filler hole 3.
- Refit and tighten the drain plug 1 (tightening torque 29 - 39 N.m).
- Unscrew the breather 4 and replace with a new one (
BELTS) (tightening torque 3 - 7 N.m).
- Fill the fuel tank with clean diesel filtered through the filler port.
- Refit the filler plug.
REPLACE
These operations are to be carried out as necessary or every 2 years at the beginning
of winter. Place the lift truck on level ground with the engine stopped and cold.
The engine does not contain any anti-corrosion elements and must be filled throughout the year with a mixture
containing 25% ethylene glycol-based antifreeze.
DRAINING THE LIQUID
- Open the engine cover.
- Remove access panel 1.
ALSO PERFORM THE 500 HOUR PERIODIC MAINTENANCE OPERATIONS.
t
IMPORTANT
Immediately repair or replace the seat belt.
t
t
IMPORTANT
e
t
t
IMPORTANT
3 - 28
t
Fuel tank
Fuel tank breather
 FILTER CARTRIDGES AND
Coolant
www.duma-rent.com
Seat belt
1
2
3
4
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mt 933 easy 75d st5 s1Mt 1033 easy 75d st5 s1

Table of Contents

Save PDF