Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 144

Ü OCCASIONAL MAINTENANCE
CLEAN
If you are performing regeneration during the periodic 500-hour service, do the regeneration before replacing
- Park the lift truck in a safe and adequately ventilated place.
- Check the following points:
• forward/reverse selector in neutral,
• parking brake applied,
• no action on the hydraulic control joystick,
• boom in transport position,
• idling speed,
- Check that the fuel level is sufficient.
- Start the lift truck and run the engine for a few minutes to bring it up to its normal
operating temperature.
- Press the top of switch 1 and hold for at least two seconds to launch exhaust regeneration. Indicator lamp
on fixed and the engine speed increasing confirm the start of regeneration.
- The length of the exhaust regeneration procedure varies (between 40 and 50 minutes).
- When regeneration is complete, the indicator lamp
to 700 hours (700h => 0h).
REPLACE
For this operation, we advise you to use the hydraulic jack (MANITOU part no.: 505507)
and the safety support prop (MANITOU part no.: 554772).
In the event of a wheel being changed on the public highway, secure the lift truck vicinity:
- Stop the lift truck, if possible on firm, level ground.
e
- Stop the lift truck (
INSTRUCTIONS UNLADEN AND LADEN).
- Switch on the hazard warning lights.
- Immobilise the lift truck in both directions on the axle opposite to the wheel to be
changed.
- Unlock the nuts of the wheel to be changed.
- Place the jack under the flared axle tube, as near as possible to the wheel and adjust
the jack.
- Raise the wheel until it is clear of the ground and place the safety support under
the axle.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Hand-tighten the nuts, grease them if necessary.
- Remove the safety support and lower the lift truck with the jack.
- Tighten the wheel nuts with a torque wrench (
SERVICE - EVERY 2,000 HOURS OF SERVICE OR EVERY 4 YEARS) for the tightening torque.
"Stationary lift truck" exhaust regeneration
t t
IMPORTANT
the engine oil.
t
IMPORTANT
Exhaust regeneration must only be stopped if absolutely necessary.
Regeneration stops automatically if the operator:
- activates the hydraulic control joystick,
- engages forward or reverse gear,
- switches off the engine,
- presses switch 1.
t t
IMPORTANT
1 - OPERATING AND SAFETY INSTRUCTIONS: DRIVING
t
goes out and the countdown to next regeneration screen reverts
Wheels
e
2000H - PERIODIC
3 - 38
www.duma-rent.com
1
coming