Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 137

REPLACE
CLEAN
Place the lift truck on level ground with the engine stopped and the gear box oil still warm.
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (
RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
Dispose of the drain oil in an ecological manner.
DRAINING THE OIL
- Place a container under drain plug 1 and under cover 2 and unscrew the drain plug.
- Remove the cover plate 3.
NOTE: When removing cover plates and hatches, clean the surrounding area and remove
any accumulations of flammable materials.
- Remove dipstick 4 and unscrew filling plug 5 in order to ensure that the oil is drained
properly.
CLEANING THE STRAINER
- Remove cover 2 and set aside the O-ring joint and sealing washer.
- Allow the rest of the oil to drain away.
- Remove and clean the strainer using a compressed air jet.
- Clean the magnetic section on the plate.
- Refit the assembly and tighten up plate 2 (tightening torque 18 - 31 N.m).
FILLING WITH OIL
- Refit and tighten the drain plug 1 (tightening torque 34 - 54 N.m).
e
- Fill up with oil ( LUBRICANTS AND FUEL) through the filler port 5 and refit the plug.
- Start the engine and let it run for a few minutes.
- Check any possible leaks from the drain plug or cover.
- Stop the engine, and within 5 minutes of the engine being stopped, check the correct
level between the MIN and MAX marks on the dipstick 4.
- Top up the level if necessary.
- Refit cover plate 3.
t t
IMPORTANT
3 - 31
Gearbox oil
Gearbox sump strainer
e
1 - INSTRUCTIONS AND SAFETY
www.duma-rent.com
1
2
3
5
4