Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 138

REPLACE
Place the lift truck on level ground with the engine stopped, the angle gear box oil still
warm.
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (
AND SAFETY RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
Dispose of the drain oil in an ecological manner.
- Place a container under drain plug 1 and unscrew the plug.
- Remove dipstick 2 and unscrew filling plug 3 in order to ensure that the oil is drained
properly.
- Refit and tighten the drain plug 1 (tightening torque 20 - 29 N.m).
e
- Fill up with oil ( LUBRICANTS AND FUEL) through the filler port 3 and refit the plug.
- Check the correct level between the MIN and MAX marks on dipstick 2.
- Check for any possible leaks at the drain plug.
REPLACE
REPLACE
Place the lift truck on level ground with the engine stopped and the reducers' oil still warm.
Dispose of the drain oil in an ecological manner.
- Drain and change the oil of each wheel reduction gear.
- Place drain plug 1 in position A.
- Place a container under the drain plug and unscrew the plug.
- Let the oil drain fully.
- Place the drain port in position B, i.e. in a level port.
e
- Fill up with oil ( LUBRICANTS AND FUEL) through level hole 1.
- The level is correct when the oil level is flush with the edge of the hole.
- Refit and tighten the drain plug (tightening torque 34 - 49 N.m).
t t
IMPORTANT
t t
IMPORTANT
3 - 32
Angle gear box oil
e
1 - INSTRUCTIONS
Front wheel reducer oil
Rear wheel reducer oil
www.duma-rent.com
1
2
3
1
B
A