Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 77

Hide thumbs Also See for MT 733 EASY 75D ST5 S1:
Table of Contents

Advertisement

Main screen.
Daily hour meter screen.
Engine fault screen.
ECU fault screen.
Instantaneous consumption screen.
Countdown to next regeneration screen (700h => 0h).
Main screen.
HELP SCREENS
WARNING SCREENS
This screen is displayed for 3 seconds every 10 minutes in the event that there is water in the diesel. Drain
the fuel pre-filter (
ENGINE PREHEAT INDICATOR LAMP
Preheat is necessary. When the lift truck is switched on, the indicator lamp comes on for 2 seconds and goes off as soon
as preheat is ended. Start the lift truck's engine.
ENGINE FAULT INDICATOR LAMP
If the indicator lamp comes on or flashes while the lift truck is in operation, a diagnostic fault has been detected. The lift truck
will operate in reduced mode. Consult your dealer without delay.
STOP
CUT-OFF ENGINE INDICATOR LAMP
If the indicator lamp lights up or flashes, when the lift truck is running, stop the engine immediately and consult your dealer.
STEERING SYSTEM OIL PRESSURE WARNING INDICATOR LAMP
If the indicator lamp lights up when the lift truck is running, stop the engine immediately and determine the cause (possible
leak, etc.).
Self-cleaning fan, these screens are displayed for 3 seconds.
e
 3 - MAINTENANCE: 10H - DAILY OR EVERY 10 HOURS OF SERVICE).
2 - 39
To set the time, short press to increment the value or hold down
to move to the next number.
Reset to zero.
Fault code display.
Fault code display.
www.duma-rent.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mt 933 easy 75d st5 s1Mt 1033 easy 75d st5 s1

Table of Contents