Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 155

2 - HYDRAULIC ATTACHMENT AND MANUAL LOCKING DEVICE
FITTING AN ATTACHMENT
- Ensure that the attachment is in a position facilitating the locking to the carriage. If
it is not correctly oriented, take the necessary precautions in order to move it safely.
- Check that the locking pin is in position in the bracket (Fig. A).
- Place the lift truck with the boom lowered in front of and parallel to the attachment,
and tilt the carriage forwards (Fig. B).
- Bring the carriage under the locking tube of the attachment, slightly raise the boom,
tilt the carriage backwards in order to position the attachment (Fig. C).
- Lift the attachment off the ground to facilitate locking.
MANUAL LOCKING AND CONNECTION OF THE ATTACHMENT
Make sure that the rapid connectors are clean and protect the holes which are not used, with the caps provided.
- Take the locking pin on the bracket and lock the attachment (fig. D). Do not forget
to fit the cotter pin.
- Stop the engine and keep the ignition on the lift truck.
- Release the pressure in the attachment hydraulic circuit by moving switch 1 on
the hydraulic controls lever backwards and forwards 4 or 5 times.
- Connect the quick-release couplers according to the logic of the attachment's
hydraulic movements.
MANUAL RELEASE AND DISCONNECTION OF THE ATTACHMENT
- Proceed in the reverse order of paragraph MANUAL LOCKING AND CONNECTION
OF THE ATTACHMENT, taking care to refit the locking pin in the bracket.
REMOVING THE ATTACHMENT
- Proceed in the reverse order to FITTING AN ATTACHMENT, taking care to store
the attachment flat on the ground and in the closed position.
q q
IMPORTANT
D
4 - 5
www.duma-rent.com
A
B
C
E
1