Manitou MT 733 EASY 75D ST5 S1 Operator's Manual page 141

REPLACE
CLEAN
REPLACE
REPLACE
Place the lift truck on level ground with the engine shut down, and the boom retracted
and lowered as far as possible.
Before any intervention, thoroughly clean the area surrounding the filter, the drain plugs and the suction cover on
Dispose of the drain oil in an ecological manner.
Use a very clean container and funnel and clean the underside of the oil drum before filling.
DRAINING THE OIL
- Place a container under drain plugs 1 and unscrew them.
- Remove level and filling plug 2 to ensure that the oil is drained properly and discard.
CLEANING THE STRAINER
- Remove the inlet cover 3.
- Remove and clean the suction strainer using a compressed air jet, check its condition
and replace if necessary (
- Refit the strainer and tighten the inlet cover 3 (tightening torque 81 N.m) making
sure the seal is in the correct position.
REPLACING THE DISTRIBUTOR CONTROL HEAD FILTER
Be careful to mount the filter 6 in the same direction as the arrow.
- Remove the half clamp 4.
- Undo the two couplings 5 and replace the filter 6.
- Refit half clamp 4.
FILLING WITH OIL
- Clean and refit the drain plugs 1 (tightening torque 29 - 39 N.m).
e
- Fill up with oil ( LUBRICANTS AND FUEL) through filler hole 7.
- Observe the oil level on dipstick 8, the oil level should be at the level of the red dot.
- Check for any possible leaks at the drain plugs.
- Replace filler plug with a new filler plug 2 (
Hydraulic oil tank suction strainer
Distributor control head filter
t t
IMPORTANT
the hydraulic tank.
e
FILTER CARTRIDGES AND BELTS).
t t
IMPORTANT
e
FILTER CARTRIDGES AND BELTS).
Hydraulic oil
Hydraulic oil tank filter cap
3 - 35
www.duma-rent.com
1
1
2
7
3
4
5
5
6
8