LUBRICATE
- Clean and lubricate the pivot pins 1 with grease (
REPLACE
REPLACE
Place the lift truck on level ground, let the engine run at idling speed for a few minutes,
then stop the engine.
Dispose of the drain oil in an ecological manner.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
DRAINING THE OIL
- Open the engine cover.
- Remove access panels 1 and 2.
NOTE: When removing cover plates and hatches, clean the surrounding area and remove
any accumulations of flammable materials.
- Place a container under the drain hole and unscrew the drain plug 3.
- Take drain hose 4.
- Place the end of the drain hose in the container and screw the hose fully to the
drain connector 3.
- Remove the filler plug 5 to ensure correct drainage.
REPLACEMENT OF THE FILTER
- Unscrew and discard the engine oil filter 6, together with its seal.
- Clean the filter bracket with a clean, lint-free cloth.
- Lightly oil the seal before refitting the new oil
e
filter (
FILTER CARTRIDGES AND BELTS) on
its bracket (tightening torque 15 - 17 N.m).
FILLING WITH OIL
- Remove, clean and refit drain hose 4.
- Refit and tighten the drain plug 3.
e
- Fill up with oil (
LUBRICANTS AND FUEL)
through filler hole 5.
- Wait a few minutes to allow the oil to flow
into the sump.
- Start the engine and let it run for a few
minutes.
- Check for possible leaks from the drain plug
and the oil filter.
- Stop the engine, wait a few minutes and check
the correct level between the two marks on
the dipstick 7.
- Top up the level if necessary.
- Refit access panels 1 and 2.
Parking brake lever mechanism
e
LUBRICANTS AND FUEL).
t
t
IMPORTANT
5
3 - 25
www.duma-rent.com
Engine oil
Engine oil filter
2
4
3
7
1
1
1
1
3
4
6