Forward/Neutral/Reverse Gear Selection; Hydraulic Controls - Manitou MT 733 EASY 75D ST5 S1 Operator's Manual

19 - FORWARD/NEUTRAL/REVERSE GEAR SELECTION

When changing the direction of travel, the lift truck should be travelling
at slow speed and not accelerating.
• FORWARD: Push the switch forward (position A).
• REVERSE: Push the switch backward (position B). Reversing lights
and an acoustic reversing alarm indicate that the lift
truck is travelling in reverse.
• NEUTRAL: The switch must be in the neutral position (position C)
to start the lift truck.
SAFETY FOR MOVING THE LIFT TRUCK
The operator must observe the following sequence to move the truck
forwards or backwards:
1 - sit down correctly in the driver's seat,
2 - release the hand brake,
3 - engage forward or reverse.
NOTE: The alternating display of F/N or R/N on the screen and a rapid, discontinuous audible signal indicates that the selector
needs to be set to neutral.
To stop the forklift truck without switching off the ignition, the following sequence must be followed:
1 - Set the forward/reverse selector to neutral,
2 - Apply the parking brake,
3 - Get out of the lift truck.
NOTE: A discontinuous audible signal and a message on the screen will inform the driver if he has left the driver's cab
without applying the parking brake.

20 - HYDRAULIC CONTROLS

Do not attempt to alter the hydraulic system pressure by interfering with the pressure regulating valve. In the event of suspected malfunction, contact your dealer. ANY
ALTERATION MAY RENDER THE WARRANTY NULL AND VOID AND INCURS LIABILITY IN THE EVENT OF AN ACCIDENT.
Use the hydraulic controls gently without jerking, to avoid incidents caused by shaking the lift truck.
NOTE: If necessary, operate the steering to reset the hydraulic control steering accumulator.
HYDRAULIC CONTROLS ACTIVATION
This safety device prevents accidental operation of the hydraulic lifting, tilting, telescoping and attachment controls.
USING THE BUTTON
-Hydraulic controls activation is maintained on a timer while the lift truck is being used.
-If necessary, reactivate the hydraulic controls.
t
IMPORTANT
-Place your hand on the lever, activate
the hydraulic controls by pressing
the button and perform the hydraulic
movement.
2 - 50
www.duma-rent.com
C
B
A
t
USING THE CAPACITIVE SENSOR
-Place your hand on the lever, activate
the hydraulic controls by contact on
the capacitive sensor and perform
the hydraulic movement.