Snmp Trap Addmodify - 3Com 4007 Command Reference Manual

snmp trap addModify

Layer 2
Switching
Modules
Multilayer
Switching
Modules
Adds or modifies trap reporting destination configurations. When an
event occurs, the system sends the trap that you specify here to the
destination address.
Valid Minimum Abbreviation
sn t a
Important Considerations
You can define up to 10 destination addresses and the set of traps
that are sent to each destination address.
No unlisted traps are transmitted.
Specify a range of more than two trap numbers with a hyphen (-) and
nonsequential trap numbers with commas.
If the destination address that you entered is not a valid end station, if
a valid IP interface is not defined on the system, or if the agent does
not have a route to the destination, the agent displays this message:
Trap address invalid or unreachable
If you see this message, verify the IP address of the end station, that it
is online, and that a route exists to the intended management station.
See the "Device Monitoring" chapter in the Switch 4007
Implementation Guide for an explanation of what the individual traps
mean.
Options
Prompt Description
Trap Destination IP address of the
destination SNMP manager
address
Trap Traps that you want to direct
numbers to to the SNMP Manager
enable
snmp trap addModify
Possible Values [Default]
A valid destination –
IP address
A valid trap #, –
range, or
sequence of
valid trap #s
all
? (for a list of
available trap
numbers)
73