Ip Route Static - 3Com 4007 Command Reference Manual

246 C 12: I
HAPTER NTERNET

ip route static

Layer 2
Switching
Modules
Multilayer
Switching
Modules
P (IP)
ROTOCOL
Defines a static route on a Multilayer Switching Module.
Valid Minimum Abbreviation
ip route s
Important Considerations
Before you can define static routes, you must define at least one IP
interface. See "ip interface define" earlier in this chapter for more
information.
You can define up to 64 static routes.
Static routes remain in the table; you must remove them before you
can remove the corresponding interface.
Static routes take precedence over dynamically learned routes to the
same destination
Static routes are included in periodic Routing Information Protocol
(RIP) updates that the module sends.
Options
Prompt Description
Destination IP IP address of the
address destination network,
subnetwork, or host
for this route
Subnet mask Subnet mask for the
specified IP address
Gateway IP IP address of the
address gateway that this
route uses
Possible Values
A valid IP address
A valid subnet mask
A valid router address
[Default]
–
Based on
specified IP
address
–