3Com 4007 Command Reference Manual page 511

Prompt Description
Custom Hex values for
nonflow classifiers
protocol
hexidecimal with the protocol
value (custom custom type
nonflow
classifiers only)
802.1p tag For nonflow
classifiers only, IEEE
802.1p tag values
Flow Classifier Procedure
To accept the default or current values that appear in brackets [ ], press
Enter.
1 Enter a classifier number in the range of from 1 through 399.
Flow classifiers 20 and 23 are predefined for FTP and Telnet.
2 Enter the classifier name (a unique name of up to 32 characters).
3 Enter a cast type.
For a flow classifier, the options are
4 Enter the IP protocol type of
5 Enter the source IP address. The default value is 0.0.0.0.
6 Enter the source IP address mask. The default value is 0.0.0.0.
7 Enter the destination IP address.
8 Enter the destination IP address mask.
9 Enter the start of the TCP or UDP source port range, in the range of from
0 through 65535. The default is 0.
10 Enter the end of the TCP or UDP source port range using a value of up to
65535.
Possible Values
Ethertype hex value of
0x0 – 0xfffe
DSAP hex value of
0x0 – 0xff
Note: You cannot enter
0xaa - 0xaa
SSAP hex value of
0x0 – 0xff
Note: You cannot enter
0xaa - 0xaa
Any combination of
priority tag values in the
range of
0 – 7
all
? (for a list of possible
values)
,
unicast multicast
, , or .
TCP UDP all
511
[Default]
0x0
–
0x0
–
, and .
all