Ip Advancedtraceroute - 3Com 4007 Command Reference Manual

300 C 12: I
HAPTER NTERNET
ip
advancedTraceRoute
Layer 2
Switching
Modules
Multilayer
Switching
Modules
P (IP)
ROTOCOL
Tracks a route from a Multilayer Switching Module to a destination using
one or more of the advanced traceRoute options.
Valid Minimum Abbreviation
ip advancedT
Important Considerations
When you specify a host name, the host name and its associated IP
address must be configured on a network name server. Also, you must
add the IP address on the name server to the list of name server
addresses that are associated with the network domain name. See "ip
dns domainName" earlier in this chapter for more information.
To interrupt the command, press Enter.
Options
Prompt Description
Host name or Host name or IP address of the
IP address destination that you want to ping.
Maximum ttl Maximum number of hops that the
module can use in outgoing probe
packets.
Destination Destination (or base) UDP port
port number that the module uses in
probe packets. Set the destination
UDP port number to be very high to
ensure that an application at the
destination is not using that port.
Probe count Maximum number of probes that the
module sends at each TTL level.
Wait Maximum amount of time that the
module waits for a response to a
probe.
Packet size Number of bytes that the module
sends in each UDP probe packet.
Source address Source address other than the one
from which the probe packets
originate. This option is available if
you have more than one IP interface
defined on the module.
Possible
Values [Default]
A valid host 0.0.0.0
name
IP address
1 – 255 hops 30
30000 – 33434
65535
1 – 10 3
1 – 10 seconds 3
28 – 4096 28
bytes
n (no) y
y (yes)