Bridge Multicast Igmp Querymode - 3Com 4007 Command Reference Manual

3com 4007: reference guide

Hide thumbs Also See for 4007:

Table of Contents

bridge multicast igmp

Enables or disables the querying function of the Internet Group

Management Protocol (IGMP) on Layer 2 Switching Modules. From all

IGMP-capable devices on a given subnetwork, the one with the lowest IP

address is elected as the querier.

Valid Minimum Abbreviation

b mu i querym

Important Considerations

The value that you select applies to the entire module.

If you enable igmp querymode, but disable igmp snoopmode, the

module cannot operate as an IGMP querier.

To prevent IP multicast traffic from occupying unnecessary bandwidth,

the best device to operate as the querier is the one closest to the

source of IP multicast traffic. You can disable querying on select

devices or manipulate IP addresses with the

queryIpAddress

On Multilayer Switching Modules, IGMP commands exist under the

ip multicast igmp

Whether the module can

operate as the IGMP querier if

command to force this configuration.

Possible Values

bridge multicast igmp

enabled (factory

default), or

current value