3Com 4007 Command Reference Manual page 528

528 C 18: Q
HAPTER UALITY OF
S (Q S) R
ERVICE O AND ESOURCE
4 For the
receivePort
conforming packets as
For the rate limit type, enter the service level for conforming packets
none
as , ,
high best low
The default is best (best effort).
If you use , the module drops all traffic on all ports for the classifier
drop
that is associated with the control. Ping packets are ICMP, not UDP/TCP, so
they are not dropped.
5 Specify whether the conforming packets are loss eligible (
default is .
no
6 If you have selected receivePort or aggregate for the rate limit
type, you are prompted for the following information:
a Enter the service level for excess packets (
The default is
best
b Specify whether excess packets are loss eligible (
is .
yes
c Specify how the rate limit is expressed (
or .
KBytes/sec
d If you specified
rate limit in KBytes/sec (0 through 65434).
If you specify that you want a
the percentage in the range of from 0 through 100 percent. These
numbers are rounded to the nearest 16 KBytes/sec. A value of 0
makes all packets excess packets.
e Enter the burst size in KBytes (16 through 8192, with the default
value depending on your specified rate limit). The burst size is the
maximum amount of data that you can transmit at the line rate before
the transmission is policed.
f Specify the receive ports for which you want to enable the rate limit
(specific bridge ports or all bridge ports).
If you apply the rate to only one or a subset of the bridge ports, you
are prompted to specify whether you want to define another rate limit
for another set of bridge ports. If you specify yes, you are prompted
to enter another rate limit and burst size for another set of ports. This
sequence of prompting continues until you specify n, meaning that
you do not want to define another rate limit for another set of ports.
R P
ESERVATION ROTOCOL
or limit type, enter the service level for
aggregate
, , or
high best low
, or .
drop
.
is the default.
KBytes/sec
for the rate limit, enter the value for the
KBytes/sec
percentage
(RSVP)
.
or
yes
, , , or
high best low
or ).The default
yes no
of port bandwidth
percentage
for the rate limit, specify
). The
no
).
drop