Table of Contents
Advertisement
1. Introduction
USB 2.0 HUB
DP-OPT-TX150 connected to a computer via USB can be used as a local USB HUB with two
USB 2.0 ports.
Thunderbolt
Sources with Thunderbolt port are also supported – just connect a miniDP-DP cable between
the source and DP-OPT-TX150.
THUNDERBOLT
Front Panel LEDs
LED1
Immediate feedback about the status of connected DP source and monitor. Fiber link-, USB-
LED2
and HDCP-status are also shown on the front panel.
LED3
USB Control
USB management, information about connected devices and firmware upgrade can be
accessed with Lightware software via USB connection.
Universal Power Adaptor
Equipped with a universal +5V DC power adaptor, which accepts AC voltages from 100 to 240
Volts with 50 or 60 Hz line frequency.
Kensington Security Slot
The security slot can be found on the side of the units for theft protection.
Support
®
Applied firmware package: v1.1.13 | LDC software: v2.5.1b5
DP-OPT-TX150, DP-OPT-RX150 – User's Manual
1.6. Typical Applications
Stand-alone Diagram with a High-resolution DP monitor
Stand-alone Diagram with an HDMI Projector
Daisy-chained Thunderbolt Devices and a LED Cinema Display
7
Advertisement
Table of Contents
