Hid Proxpro Reader - Bosch Access Easy Controller Hardware Manual

Access Easy Controller
6.3

HID ProxPro Reader

1.
2.
3.
The above tests validate that the reader is functioning correctly.
If installing a keypad type reader, then you will need to further configure the reader database
before you can properly validate keypad operation. Refer to the software manual for informa-
tion of configuring the reader database to support card and PIN operating. After making nec-
essary database updates, the keypad can now be tested as described in the next section.
Bosch Security Systems
Connect the terminal strip where the cable from the reader is terminated to the proper
connector on the 4-reader board.
Result: The reader LEDs will alternately flash between red & green for a few seconds, and
the beeper in the reader will beep three times in a sequence of 2 beeps, short pause, one
beep. The LED will the remain lit in red.
Present a card to the reader.
Result: The LED should light briefly in green and the reader should sound a short beep.
This indicates that the reader recognized the card.
Depending on the setup of the controller database for the card used in the previous step,
one of two events will occur within a second of the beep in step 2. Note that either
response indicates that the reader is working.
If the card is configured in the controller's database to allow access through the reader,
then the LED will light in green for few seconds indicating that access has been granted.
Or, if the database has not yet been configured, then the LED will flash between red &
green in a rapid alternating pattern for two to three second indicating that access has
been denied.
Hardware Manual
How to Install Reader and Field Devices | en 39
Ver 2.0.0 | 2006.07