Bosch Access Easy Controller Hardware Manual page 166

166 en | Card Reader Keypad Functions
S-Series reader LED indicators
S-Series reader
Armed
The zone is Armed
Ready/Disarmed
All input points in the zone
are in normal state and ready
to be armed.
Not Ready(before Armed)
One or more input points is
not in the normal state and
not ready for arming.
Armed Partial (Some input
Bypass)
Zone failed to be armed due
to certain input point(s) are
not ready.
Armed Fail (All input Bypass)
Zone failed to be armed due
to all inputs are not ready.
Alarm
Zone is armed and one or
more input point is in alarm
state.
*Slow flashing is at around 1 sec ON then 1 sec OFF interval; whereas normal flashing is at ½ secinterval.
The LED besides being used to indicate an alarm condition in the zone is also used during the
Arming process.
When you arm the Alarm Zone, the LED will flash for the duration as depicted in the Arm Delay
field of that particular Alarm Zone. We provide a few example below for further understand-
ing.
Configuration in the AEC.
Arming an Alarm Zone
Example 1 - All Input Points are in the Normal state.
1.
2.
Ver 2.0.0 | 2006.07
Input Points #1, 2, 3, and 4 are grouped as Alarm Zone #1.
Arm Delay = 15 seconds.
Alarm Delay = 0 seconds
Reader #4 is the Arm/Disarm Reader for Alarm Zone #1.
Some cards are given the access rights to arm/disarm Alarm Zone #1. No PIN code
required.
LED has a stable green light.
Press 0 key and Present the arming card to Reader #4.
Hardware Manual
Status LED Armed
(Tri-color) LED
RED RED
GREEN OFF
GREEN/ RED
RED Flashing Flashing
AMBER/ RED
RED Flashing Flashing
RED RED Flashing OFF
RED RED Flashing RED
Access Easy Controller
Alarm Internal
LED Buzzer
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF
Beeping
Flashing ON/OFF
(slow*) at 1 Sec
interval
Bosch Security Systems