Controller Installation - Bosch Access Easy Controller Hardware Manual

24 en | How to Install the Access Easy Controller
5.2

Controller Installation

Installation and wiring must be done in accordance with all applicable electrical and safety
codes.
1.
NOTICE!
i
A UL Listed transformer (with a visual display indicating an AC power status) must be used for
the UL Listed system, in order to satisfy UL requirements.
2.
3.
4.
NOTICE!
i
This test takes about 90 seconds to complete.
Ver 2.0.0 | 2006.07
Mount the controller and strike/lock power supply.
Remove any necessary knockouts from the top and/or back of the Access Easy Controller
enclosure to provide access for wiring.
Install conduits as needed to protect wiring.
For UL Listed System: Wire the 18 VAC transformers to the Access Easy Controller, but
do not plug in the transformer at this time.
For CE Listed System: Wire the 230 VAC to the Power Supply Unit in the Access Easy
Controller, but do not switch on the power yet.
Wire AC power to the strike/lock power supply.
Pull all required wiring from the controller to field device location.
Inspect all circuit cards
Check all circuit board mounting screws for snugness.
Verify that socket mounted components are secure.
Verify jumper and switch settings of all cards.
Install any needed expansion cards.
Mount cards in cabinet.
Install IDE expansion cables.
Install power cables.
Set jumpers and switches on cards.
Apply AC power to controller.
The power LEDs should light on all circuit boards.
The CPU card should perform a power-up self-test.
Hardware Manual
Access Easy Controller
Bosch Security Systems