Bosch Access Easy Controller Hardware Manual page 200

200 en | APPENDIX E
7.
8.
NOTICE!
Once connected, you should check whether the connection is stable by typing "AT" follow by
i
enter, you should get an "OK" reply from the GMS modem.
If there is no reply or the reply is not "OK" but display some unknown character, then it is pos-
sible that the GSM Modem baudrate is incorrect. Change the baudrate and reconnect.
9.
10. Type "AT+IPR=19200" and press the enter key. You should get an "OK" replay.
11. Now you will need to change your baudrate of the Hyperterminal to 19200.
12. Click this icon
13. Click on the icon
14. Type "AT" and follows by a return, if the GSM modem replies you "OK" then the configu-
15. You will need to save the configuration into the non -volatile memory in the GSM modem.
16. Type "AT&W" and follows by a return, the GSM modem will reply you "OK".
17. Reboot the GSM modem and try connecting again to the GMS modem using the baudrate
Ver 2.0.0 | 2006.07
Click OK and you will goes to the screen to set the Baudrate, set it to to 115200bps, 8bit
data, 1 stop bit and no parity.
Click OK button to start the connection.
Once you have connected to the GMS Modem, you shouldn't change the baudrate.
to disconnect the connection.
to change the Baudrate to 19200 and then click on the icon
reconnect with the GSM modem again.
ration is complete.
19200.
Hardware Manual
Access Easy Controller
to
Bosch Security Systems