225Dlc Controller Card - Cardinal 225D SmartCell Installation And Technical Manual

Hide thumbs Also See for 225D SmartCell:
Table of Contents

Advertisement

USB-B
Port
LED1
LED2
LED3
LED4
Ethernet
Port for
iSite
Attach
Ground
wire here
USB-B
This port is used to perform firmware updates to the 225DLC controller card.
LED 1-4
The LED's are used for diagnostic purposes. For a complete explanation of their function, refer
to the DIGITAL SCALE DIAGNOSTICS, Hardware Diagnostics section of this manual.
Ethernet Port
This port is used to connect the 225D to your network to send information to the cloud for iSite.
Micro SD Card Slot
The Micro SD card slot is not used at this time.
J1, End Node Jumper
Jumper J1 is the CAN bus END NODE jumper.
NOTE: The J1 jumper must be installed for the 225D communications to the scale to operate.

225DLC CONTROLLER CARD

P4
Future Use
8200-0753-0M Rev A  225D Weight Digital Indicator
P4 – Legacy
Serial iSite
Micro SD
Card Slot
J1
End Node
J2, J3
ICAN
Jumpers
Cable
P5
Homerun
Cable
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents