Board Replacement; Option Card Replacement; Main Pcb Replacement - Cardinal 225D SmartCell Installation And Technical Manual

Board Replacement

The 225D will detect when a DLC controller or 225D mainboard has been replaced using
checksums and unique board identification numbers. Based on several parameters, it can
detect whether the option card was replaced or the mainboard was replaced and then
reconfigure the NEW card to the existing scale.

OPTION CARD REPLACEMENT

If an option card is replaced, the 225D will boot up to this screen:
NEW CARD FOUND!
WAS DIGITAL SCALE CARD REPLACED? NO
YES
The 225D will check whether the option card has been replaced in order to reconfigure the
new option card to the existing scale.
If the operator selects YES, then the 225D mainboard will upload the scale configuration to the
controller, and the 225D will immediately be able to make weight again.

MAIN PCB REPLACEMENT

If a 225D main board is replaced, the 225D will boot up to this screen:
NEW CARD FOUND!
WAS MAINBOARD REPLACED? NO
YES
The system will also check whether the 225D's main board has been replaced, so the scale
configuration can be downloaded from the controller to the main board.
If the operator selects YES, then the scale configuration will be downloaded from the controller
to the mainboard. Scale configuration includes number of load cells, all load cell IDs, and
individual load cell trim. The 225D indicator parameters will need to be entered manually
(Interval, Decimal Point Position, Zero Tracking, Filtering, Print Settings, and Serial Settings).
NOTE: A dead load calibration will need to be performed (does not require test weights).
26
BY CARDINAL
Revision 0.1.04
BY CARDINAL
Revision 0.1.04
8200-0753-0M Rev A  225D Weight Digital Indicator
DLC
DLC
NO
NO