Bypassed Sensors; Remote Control Devices; Operate The System With A Keyfob; Arming The System Using A Keyfob - 2gig Technologies EDGE User Manual

Bypassed Sensors

When sensors are left open, the system cannot be armed unless that sensor is closed (see Open and Closed Sensors,
above) or added to the system's Bypassed Sensors list . Bypassed Sensors are ones that you intentionally decide to leave
unprotected . See Force Bypassing, pg . 23 .
NOTE: Bypassed sensors offer no protection and cannot cause an alarm . Use bypass if you want to arm your
system with one or more sensors open and intentionally unprotected .

REMOTE CONTROL DEVICES

The installer can pair your system with one or more wireless keyfobs to give you the ability to arm/disarm your system
away from, but within range of, the Control Panel using the keyfob's buttons . The 2GIG EDGE Security & Smart Home
System can be paired to work with a maximum of 32 wireless keyfobs . Depending on your individual needs, keyfobs can
also be configured by the installer to activate specific alarms.

Operate the System with a Keyfob

The installer can configure each keyfob to let you perform up to five (5) remote
functions:
A Arm the System in Away Mode
»
Activate Emergency Alarm (see below)
B
Disarm the System
C Arm the System in Stay Mode
D Activate an Auxiliary Function
NOTE: Consult your installer to determine how your keyfob is configured to work with the system. Depending on
your keyfob's setting, it may or may not be configured to disarm the system.

Arming the System Using a Keyfob

You can arm the system in Stay or Away mode using a keyfob that has been paired with the system .
»
To arm the system in Stay Mode, press the Stay button on the keyfob for two (2) seconds .
»
To arm the system in Away Mode, press the Away button on the keyfob for two (2) seconds .
NOTE: Depending on setup options, if any perimeter doors or windows are open, the system may not allow arming to
Away mode with a wireless keyfob. Consult your installer to determine how this option is configured on your system.

Disarming the System Using a Keyfob

To disarm the system, press and hold the Disarm button on the keyfob for two (2) seconds .
NOTE: Consult your installer to determine how your keyfob is configured to work with the system. Depending on
the individual keyfob settings, it may or may not be configured to disarm the system.

Activating an Auxiliary Function

To activate an auxiliary function, press and hold the Auxiliary button on the keyfob for two (2) seconds .
NOTE: Consult your installer to determine how your keyfob is configured to work with the system. Depending
on the individual keyfob settings, it may be configured to set off an external siren/sounder or used to activate a
different auxiliary function .

Activating an Alarm Using a Keyfob

To activate an emergency alarm, press and hold both the Away and Disarm buttons on the keyfob for five (5) seconds.
NOTES:
1 Consult your installer to determine what type of alarm your keyfob is configured to activate. Depending on the
individual keyfob settings, this function might be disabled on your keyfob, or it might be configured to activate
an auxiliary, audible, or silent panic alarm .
2
In order to cancel an emergency alarm activated with a keyfob, you must disarm the system at the 2GIG EDGE
Panel .
3 If Smart Areas is enabled, a keyfob can be configured to perform Arm/Disarm/Alarm functions on one Smart Area.
19
A
C
Copyright © 2021 Nortek Security & Control LLC
B
D