Use The Quick Exit Button; In The Event Of An Exit Error - 2gig Technologies EDGE User Manual

Use the Quick Exit Button

The Quick Exit button gives users the ability to start an
Exit Delay countdown while the system is armed . This
gives users the ability to leave the premises through an
Exit/Entry door, instead of having to disarm and then
rearm the system .
When the Allow Quick Exit setting is enabled, the QUICK
EXIT button appears on the System Armed (STAY)
screen .
NOTE: Consult your installer to determine if the
Allow Quick Exit setting is enabled or disabled on
the system .
To use the QUICK EXIT button:
1 . Arm the system in Stay Mode . See
System, pg . 21 .
2 . At the System Armed (STAY) screen, tap QUICK
EXIT .
This starts the Exit Delay countdown to give you time to
exit through an Exit/Entry door without having to re-arm
the system . At the end of the countdown, the system
rearms itself in the Armed Stay mode .

In the Event of an Exit Error

If you arm the system and an Exit/Entry door is left in
a violated state or condition at the time the Exit Delay
countdown expires (for example, the door you exit
from doesn't close behind you), the 2GIG EDGE Panel
sounds the local alarm and the Entry Delay countdown
begins .
If you do not disarm the system when the Entry Delay
countdown begins, the system automatically begins the
alarm transmission sequence .
The panel also transmits an Exit Error report to the
Central Station and displays an Exit Error message on
the panel screen, as shown below .
System Armed—Quick Exit Button
Arming the
Alarm Transmission & Exit Error Sequence
25
Copyright © 2021 Nortek Security & Control LLC