Clearing An Alarm - 2gig Technologies EDGE User Manual

To silence the alarm sounder:
1 . When an Alarm is sounding, enter an active, user
code .
2 . Depending on how quickly you enter your code,
one of the following occurs:
a . If you enter your code before the Abort
Window Dialer Delay countdown expires,
"Disarming Canceled an Alarm Before it was
Transmitted" will be displayed .
b . If you enter your code after the Abort Window
Dialer Delay countdown expires and before
the Alarm Cancel Time expires, the following
message appears .
3 . Tap OK to dismiss the notification message.

Clearing an Alarm

If an alarm occurs while you are away, the 2GIG EDGE Panel's Piezo Sounder will sound for a preset amount of time
(as defined by the Burglary Bell Cutoff Time and/or the Fire Bell Cutoff Time) . Upon entry, the system emits repeated
beeps to warn you that an alarm was set off while you were away .
NOTE: Consult your installer to determine how the Burglary Bell Cutoff Time and Fire Bell Cutoff Time is
configured on your system. The time can be configured to last 4 minutes, 8 minutes, 12 minutes, 16 minutes, or
Unlimited (no cutoff) . The default setting for both features is four (4) minutes .
CAUTION! If the system emits fast, repeated beeps (instead of the typical Entry Delay beeps), proceed indoors
with extreme caution . For your safety, it is recommended that you immediately leave the premises, go to a
secure location, and then contact your local authorities for assistance . If you have any reason to believe an
intruder is present, do NOT enter the premises until the dwelling is deemed safe by local authorities .
Enter Your code to Silence the Alarm Screen
31
Copyright © 2021 Nortek Security & Control LLC