Network Tests; Firmware Update - 2gig Technologies EDGE User Manual

Network Tests

Tap START to run a test on network connections: LAN,
Internet and Backend .
When tests are successful, a
appears to the left of the test name . This indicates the
network is operating and the signal strength was good .
WARNING!! If a RED
test failed . If the network continues to fail, contact
your dealer for technical assistance .

Firmware Update

This option is only available if a USB update is available,
and the update was not initiated from the "pop-up" .
1 . At the System Settings screen, tap the
Firmware Update (
2 . A test will be performed to determine if the panel
is ready to be updated . If all requirements are not
met, a list will be displayed with red icons next
to any aspect of the test that did not meet the
requirement for a panel update .
3 . Tap UPDATE to begin the USB update process .
NOTE: Red icons next to a specific requirement
indicates that the test failed . Remedy the error,
then repeat steps 1 through 3 .
2GIG EDGE User Guide
GREEN check mark
appears, it indicates the
) icon .
Network Test
Firmware Update
58