Activate an Emergency Alarm
When activated, the system immediately goes into the
alarm state . The Control Panel emits a loud, patterned
warning siren and continues to sound until the system
is disarmed (see
Disarming the
system also transmits an Emergency Report to the
Central Station .
Activate a Manual Panic, Fire or Emergency
Alarm
To activate a manual alarm:
1 . Tap
.
2 . Touch and hold the Panic, Fire, or Emergency
button for two (2) seconds .
NOTE: Consult your installer about your system's
emergency key settings . Typically, all three buttons
are enabled and visible on the touchscreen
by default . However, some systems may be
configured to hide one or more of these buttons.
3 . Once the alarm situation is resolved, clear the
alarm by following the steps available in the
Event of a Burglary Alarm
PANEL INFORMATION
The Panel Information menu provides access to the
system's History, System information, Dealer Information
and Regulatory & Compliance information .
Tapping the 2GIG Logo on the Home screen accesses
the menu .
History
The History screen shows a chronological log of system events . Each event is recorded with a date and time stamp:
»
Alarms: Keeps a record of when alarm conditions are triggered and cleared .
»
Arms/Disarms: Keeps a record of when the system is armed and disarmed .
»
Bypasses: Keeps a record of when zone sensors are bypassed and unbypassed .
»
Alerts: Keeps a record of when the 2GIG EDGE Panel or a zone issue an alert . For example, low battery, AC
power loss, or tamper conditions .
2GIG EDGE User Guide
System, pg 26) . The
section, page 30 .
2GIG EDGE Panel—Alarm Button
24-Hour Alarm Buttons
Panel Information
34