Trouble-Shooting Failed Auto-Configuration; Low Voltage Fault - Pulseroller ConveyLinx-IO User Manual

T -S F
ROUBLE HOOTING AILED
The following chart lists some typical failed condition indicators and actions to take for resolution.
Failed Condition
Status LED's OK with
Unexpected Result
Status LED blinking or
solid red on one or
more modules
L V F
OW OLTAGE AULT
In instances when the ConveyLinx-IO module detects that its supply voltage has dipped below 16VDC; the
ConveyLinx-IO will turn off its digital outputs. The ConveyLinx-IO will keep this state until it has detected that its
power supply voltage has risen to at least 21VDC.
A -C
UTO ONFIGURATION
• Check all network and power connections and perform procedure again.
• For ConveyLinx-Ai2 modules controlling conveyors and/or motors, please refer
to the ConveyLinx-Ai2 User's Guide for troubleshooting details
•
Verify that there are no Ethernet Switches or PC's connected between
ConveyLinx modules. The Auto Configuration procedure will abort if a non-
ConveyLinx device is detected along the path before reaching the last node.
Modules up to that point will be configured, but the remaining modules will
not.
• When removing a ConveyLinx module from an existing network that is already
operational; be sure to wait at least 2 minutes to allow the Ethernet switches
on the remaining modules to reset before attempting a new Auto
Configuration procedure.
Auto-Configuration
Action
Publication ERSC-1008 Rev 1.1 – October 2017
33