Table of Contents
Advertisement
32
ConveyLinx-IO User's Guide
Please note that once a network has been configured; attempting to again Auto-Configure
any ConveyLinx module that is not the Auto Configuration Master will not initiate a new
Auto Configuration procedure. The ConveyLinx module will detect that it is not the most
upstream unit and abort the procedure. However the ConveyLinx module will perform its
local re-booting procedure. This procedure will take a few seconds to complete
Publication ERSC-1008 Rev 1.1 – October 2017
FIGURE 24 - AUTO-CONFIGURATION SUCCESS
Advertisement
Table of Contents
Need help?
Do you have a question about the ConveyLinx-IO and is the answer not in the manual?