Stop Mode - Daikin GYEQ20AN Service Manual

Troubleshooting the Outdoor Unit
1.4

STOP Mode

• When the slide switch
• To exit from STOP mode, set SW1 to the RUN position so that the total operated hours are
• STOP mode has five levels from 1 to 5. Use the
• You can switch the channels using the
Table 4.10/ List of STOP mode menu items
∗ During STOP mode, the display is automatically returned to STOP twenty seconds after the
1.4.1 Alarm Display
Enter STOP mode, make sure that the display [1] (CH1: alarm display) is selected in Level 1,
and press
To clear the alarm condition, hold down
121
SW1
displayed.
Note that the outdoor unit starts operation if the remote controller is in the operation mode
when SW1 is shifted to RUN.
between these levels.
Level 1
1. Alarm display Alarm display
2. Actuator check With actuator check
3. Configure items 01. ON/OFF unit
02. Not used
4. Alarm/warning Alarms/warnings
history
termination of operation.
. The alarm code is displayed.
NEXT
is switched to STOP, the unit enters STOP mode.
BACK
and
UP
Level 2
Alarm reset
Actuator check action
Each item
(memory switch)
Among alarm/warning
history Alternate display of
alarm content
for 3 seconds.
ENTER
SiAUY361411EA
NEXT
and buttons to shift
buttons.
DOWN
Level 3 Level 4
ON/OFF
display
Level 5
Item data
update
Troubleshooting