Compact Version Sf Electrical Connection For Ethernet/Ip - AUMA SA Series Operating Instructions Manual

Electrical connection
5.4.

Compact version SF electrical connection for EtherNet/IP

Short description
Technical data
Information
32
SA 07.2 SA 16.2 / SAR 07.2
Figure 27: SF electrical connection
[1] Terminal compartment (with cover)
[1A] Cable entries for mains connection (pins for motors and pins for controls)
[1B] Cable entries for network cables
[2] Socket carrier with screw-type terminals
Plug-in electrical connection with screw-type terminals for pins for motors and pins
for controls.
SF version. For power and control cable connection, remove the AUMA plug/socket
connector and the socket carrier from terminal compartment. The cover does not
have to be removed for connecting network cables.
Table 21:
Electrical connection via AUMA plug/socket connector
No. of contacts max.
Designation
Connection voltage max.
Rated current max.
Type of customer connection
Connection diameter max.
For some special motors, the connection of the power terminals (U1, V1, W1, U2,
V2, W2) is not performed via the AUMA plug/socket connector but via a terminal
board directly at the motor.
SAR 16.2 Control unit: electronic (MWG)
AC 01.2 Non-Intrusive EtherNet/IP
Power contacts Control contacts
6 (3 equipped) + protective 50 pins/sockets
earth conductor (PE)
U1, V1, W1, U2, V2, W2, PE 1 to 50
750 V 250 V
25 A 16 A
Screw connection Screw connection, crimp-type (option)
2
6 mm (flexible) 2.5 mm
2
10 mm (solid) (flexible or solid)
2