Preferences Section - Viscount Legend ‘70s Artist-W User Manual

Functioning mode of the two-switch foot switch connected to PEDAL [PROGRAM + / -].
Prog +/- Type
Values:
 Normal: the right switch is assigned to PROGRAM + function, the left switch to PROGRAM
 Inverted: the right switch is assigned to the PROGRAM
+.
NB
When using a single-switch pedal, this parameter can be used to choose between the PROGRAM
+ and PROGRAM
Pedal calibration
When connecting pedals to
be useful to perform a calibration, if the functioning range is incorrect (see the parameters Sustain Range, FC1
Range and FC2 Range under the PEDAL SETUP menu). To calibrate the pedal, follow this procedure:
1.
Scroll until you see the Sustain Range, FC1 Range or FC2 Range parameter, according to the pedal you
wish to calibrate.
2.
To start the calibration, press the data entry dial.
3.
Move the pedal to its maximum and minimum positions, checking that the MIN and MAX field show the right
percentage value.
Press the data entry dial to save the new calibration (‚Calibration stored!‛ message) or [EXIT] to cancel
4.
(‚Calibration aborted!‛ message).

PREFERENCES section

The PREFERENCES menu allows the user to customise some instrument functions.
To access this menu, enter the SYSTEM page and place the cursor on the PREFERENCES field, then press
the data entry dial.
Parameter name Description
Enable / disable the need for confirmation when loading a Program. When the parameter value is
Confirm Prg
OFF, a Program is loaded immediately when selected. When the parameter value is ON, the user
must select a Program and then press the data entry dial to load it.
Values: OFF, ON
All Notes Off Turn off, changing Program, of any notes.
Values: Disabled, Enabled
Leds Intensity Brightness of all the Leds on the panel.
Values: between 1 and 8
Display Contrast Set the OLED display contrast.
Values: between 1 and 8
USB to Device Functioning mode of the [USB TO DEVICE] port.
Values:
 Flash Drive: for the use with a USB flash drive.
 Charger: to charge a tablet or smartphone.
USB Audio Level Signal level of the USB stereo Audio received through the [USB TO HOST] connector.
Values: between1 a 127
Memory Lock Prevents from saving Programs and Songs, together with loading backup files, so as to avoid
undesired memory overwriting.
Values: OFF, ON
Auto Power Off How long the instrument has to be idle before it shuts down automatically.
Values: Disabled, 30 min, 120 min
NB
To switch on the instrument after it was shut down by the Auto Power Off function, set the [POWER] switch to ‚0‛
-
(OFF), wait 10 seconds, then set the switch to ‚1‛ (ON).
- All unsaved data is lost when the instrument shuts down automatically. To prevent that, always save the changes
you don't want to lose.
–
functions .
PEDAL [SUSTAIN], PEDAL [FOOT CONTROLLER 1] and [FOOT CONTROLLER 2]
EN - 57
System menu
–
function, the left switch to PROGRAM
Legend '70s – User Manual
–
.
it might