E.piano Section - Viscount Legend ‘70s Artist-W User Manual

Modifying a Program

E.PIANO section

The E.PIANO menu includes all the configuration parameters of the E.
PIANO module (page 11).
To access this menu, enter the EDIT PROGRAM screen (page 28),
place the cursor on the E.PIANO field and press the data entry dial or,
alternatively, hold down the sound selection knob of the module for a
short while (point 4, page 11).
NB
The following table includes all the available parameters of the E.PIANO module. The knob or button that allows direct
control of the parameter through the panel is written below the parameter name.
Parameter name Description
Name of the selected timbre. There are 8 electric piano timbres, differing in their electrical and
Timbre
mechanical characteristics. Use the Legend '70s Editor application to modify the selected timbre.
[timbre selector]
Changes made through this application affect all Programs.
Values:
 Rhod 1, Rhod 2, Rhod 3, Rhod 4, Rhod 5: ‚tine‛ type electric piano (Rhodes).
 Wurli 1, Wurli 2: ‚reed‛ type electric piano (Wurlitzer).
 E.Grand: Grand electro-acoustic piano (CP-80).
Activate / deactivate the module
Switch
[ON/OFF] Values: OFF, ON
Volume Level of the module generated signal.
[VOLUME] Values: between 0 and 127
Output Routing Assign the module audio output.
Values:
 Main L-R: AUDIO OUT [MAIN L/MONO] and [MAIN R] connectors on the rear panel (stereo
signal)
 FX1: input of the EFFECTS section FX1
 FX2: input of the EFFECTS section FX2
 FX1+FX2: inputs of both FX1 and FX2 of the EFFECTS section.
 Aux1 Mono: AUDIO OUT [AUX 1] connector on the rear panel (mono signal).
 Aux2 Mono: AUDIO OUT [AUX 2] connector on the rear panel (mono signal).
 Aux1-2: AUDIO OUT [AUX 1] and [AUX 2] connectors on the rear panel (stereo signal).
Reverb Send Level of the audio signal generated by the module and sent to the Reverb effect.
Values: between 0 and 127
NB
This parameter only works if the audio output selected through the Output Routing parameter is
MAIN L-R.
Detune Tuning of the sound generated by the module, expressed in hundredths of semitone (or cent).
Values: between -50 and +50 semitone cents.
Module sound transposition (in semitones).
Note Shift
Values: between -48 and +48 half-tones.
NB
When transposition is applied, the [
Legend '70s – User Manual
Sound
Module
Output
Routing
] module Led is on.
EN - 42
Master MAIN
Reverb
EQ
FX Out
FX1
Routing
FX Out
FX2
Routing
depends on FX Config
AUX1
AUX2
L-R