Using Sounds; Using Effects - Viscount Legend ‘70s Artist-W User Manual

Foot controller
A foot controller, or expression pedal, allows
continuous control of a parameter, unlike a
footswitch.
Pedals connected to
CONTROLLER 1] and [FOOT CONTROLLER 2]
connectors can be assigned a range of
parameters, such as a Sound volume, tuning,
modulation, Wah-Wah and more.
Foot controllers are not included. There are two
types of foot controllers on the market: RTS and
TRS. The pedal type must be set correctly on
the Legend '70s.
NB
- To set a pedal's type and polarity, read the chapter Pedal Setup Section, page 56.
- To assign a function to a pedal, read Common Section, page 29.
- To avoid undesirable effects, always connect and disconnect pedals while the instrument is switched off.
-

Using sounds

Legend '70s features a wide range of sounds, also depending on the installed modules. As already described,
each single module contains several sound types. One or more modules can be played at the same time, up to
all active modules together.
To use one or more sounds, follow the procedure.
1.
Switch on the module of the desired sound by pressing its [ON/OFF] button.
2.
Turn the selection knob to select the sound (or sound group, for modules that have them e.g. SOUND
COLLECTION).
3.
If the module has sound groups, use the sound selection knob to choose a sound.
4.
Use the dedicated module controls to set the main sound parameters.
For a thorough description of sound parameters, read the description of the module Sections that can be found
under the EDIT menu (page
a short while.

Using effects

Legend '70s includes a high quality effects section, comprised of two independent effect processors: FX1 and
FX2, of a reverb unit and a 3-band equalizer unit. The main effect parameters can be controlled through the
main panel. For a complete configuration of all parameters, access the dedicated sections under the EDIT
menu. To control the FX1 or FX2 effect, first select it by pressing the respective button [1] or [2] of the
EFFECTS section on the panel.
The complete effects routing is explained by the following image:
Sound
Module
the PEDAL [FOOT
42 and following) or by holding down the sound (or sound group) selection knob for
FX1
FX2
PEDAL FOOT CONTROLLER
[1] and [2] jacks
Reverb
Output
Routing
EN - 23
Switching on and basic functions
Master MAIN
EQ L-R
AUX1
AUX2
Legend '70s – User Manual