Pedal Setup Section - Viscount Legend ‘70s Artist-W User Manual

System menu

PEDAL SETUP section

The PEDAL SETUP menu provides the parameters to configure the pedals connected to the PEDAL jack on the
rear panel.
To access this menu, enter the SYSTEM page and place the cursor on the PEDAL SETUP field, then press the
data entry dial.
Parameter name Description
Type of pedal connected to the PEDAL [SUSTAIN] connector.
Sustain Type
Values:
 Half-Damper: continuous control sustain pedal, to be used with the half-pedaling technique.
 Switch: foot switch.
 Triple: Studiologic SLP-3D triple pedal.
Sustain Polarity Polarity of the pedal connected to the PEDAL [SUSTAIN] connector.
Values:
 Auto: polarity is automatically detected when switching on the instrument.
 Open (when Sustain Type: Switch): Normally open pedal (N.O.)
 Closed (when Sustain Type: Switch): Normally closed pedal (N.C.).
 Type1 (with Sustain Type: Half-Damper): pedal such as Yamaha FC3A.
 Type2 (with Sustain Type: Half-Damper): pedal such as Roland DP-10.
NB
- Do not press the pedal while switching on the instrument and when selecting polarity.
- This parameter has no effect if Sustain Type is set to Triple.
Sustain Range Position and range covered by the pedal connected to the PEDAL [SUSTAIN] connector. This
page also allows the user to calibrate the sustain pedal (page 57).
Values: between 0 and 100%
FS1 Polarity Polarity of the foot switch connected to PEDAL [FOOT SWITCH 1] and [FOOT SWITCH 2].
FS2 Polarity Values:
 Auto: polarity is automatically detected when switching on the instrument.
 Open: normally open pedal (N.O.).
 Closed: normally closed pedal (N.C.).
NB
Do not press the pedal while switching on the instrument and when selecting polarity.
Type of foot controller connected to PEDAL [FOOT CONTROLLER 1] and [FOOT CONTROLLER
FC1 Type
2].
FC2 Type
Values:
 Type1: pedal with RTS connector, such as Yamaha FC7.
 Type2: pedal with TRS connector, such as Fatar VP/25.
Position and range covered by the pedal connected to PEDAL [FOOT CONTROLLER1] and
FC1 Range
[FOOT CONTROLLER 2].
FC2 Range
This page also allows the user to calibrate the foot controller (page 57).
Values: between 0 and 100%
Prog +/- Polarity Polarity of the two-switch foot switch connected to PEDAL [PROGRAM + / -].
Values:
 Auto: polarity is automatically detected when switching on the instrument.
 Open: normally open pedal (N.O.).
 Closed: normally closed pedal (N.C.).
NB
- When using a two-switch foot switch with opposite polarities, select the Auto setting.
- Do not press the pedal while switching on the instrument and when selecting polarity.
Legend '70s – User Manual
TYPE 1
Sleeve Ring Tip
Sleeve Ring
GND
Wiper
EN - 56
Sleeve
Tip
Supply
TYPE 2
Ring
Tip
Sleeve Ring Tip
GND Wiper
Supply