Clavi Section - Viscount Legend ‘70s Artist-W User Manual

CLAVI section

The CLAVI menu includes all the configuration parameters of the
CLAVI module (described at page 13).
To access this menu, enter the EDIT PROGRAM screen (page 28)
place the cursor on the CLAVI field and press the data entry dial or,
alternatively, hold down either the [Clavi 1] or [Clavi 2] buttons for a
short while (point 6, page 14).
NB
The following table includes all the available parameters of the CLAVI module. The knob or button that allows direct
control of the parameter through the panel is written under the parameter name.
Parameter name Description
Timbre Name of the selected timbre. The timbres simulates the two most famous models of the Clavinet
piano. Use the Legend '70s Editor application to adjust the selected timbre. Changes made
[Clav 1]
through this application affect all Programs.
[Calv 2]
Values: Clavi 1 (D6 model), Clavi 2 (E7 model)
Same function of the parameters described at page 42.
Switch
Volume
Output Routing
Reverb Send
Note Shift
Detune
Velocity Sens
Pitch Bend
Mod.Wheel
Sustain Pedal
Foot Switch1
Foot Switch2
Foot Control1
Foot Control2
Enable / disable the high-pass filter, that starkly increases the sound brilliance.
Brilliant Control
[BRILLIANT] Values: OFF, ON
Treble Control Activate / deactivate the band-pass filter, very rich on the treble frequencies.
[TREBLE] Values: OFF, ON
Medium Control Activate / deactivate the low-pass filter, with cutoff frequency on the middle frequencies .
[MEDIUM] Values: OFF, ON
Enable / disable the low-pass filter, for a more closed or muffled sound.
Soft Control
[SOFT] Values: OFF, ON
Pickup configuration.
C D Control
[C D] Values:
 C: activate a single pickup.
 D: activate both pickups.
Pickup configuration.
A B Control
[A B]

If the parameter C D = C
Select pickup.
 A: lower pickup
 B: higher pickup

If the parameter C D = D
Phase selection.
 A: pickups in same phase.
 B: pickups in opposite phase
NB
Combining the values of the parameters C D Control and A B Control there are 4 possible sound
configurations. For further information, read point 4, page 13.
Mute Activate / deactivate the sliding damper.
Values: OFF, ON
Mute Value Maximum position of the mute (sliding damper), than decreases the sound decay time.
Values: between 30 and 127
EN - 45
Modifying a Program
Legend '70s – User Manual