Factory Reset Function; Release/Update Function - Viscount Legend ‘70s Artist-W User Manual

Utility menu
NB
To avoid losing the data on the instrument, first make a backup of the data through the Backup All function (page 59)
and only then load the data from the USB drive.

FACTORY RESET function

The Factory Reset function restores all the original Programs, Songs and system parameters of the instrument's
factory settings.
To perform a Factory Reset, follow this procedure:
1.
Access the UTILITY screen of the SYSTEM menu, then select the Factory Reset function and press the
data entry dial. The system will ask for a confirmation: ‚Reset all data in internal mem. Are you sure?‛. If you
accept, all the user customisations on the instrument will be irreparably lost. Press the dial to confirm or
[EXIT] to abort.
During the procedure the message ‚Executing Factory Reset...‛ will appear on screen. When the procedure
2.
is over, the instrument restarts automatically.
NB
To avoid losing the data on the instrument, first make a backup of the data through the Backup All function (page 59)
and only then perform the factory reset.

RELEASE/UPDATE function

The Release/Update function can be used to check the operating system version currently running on the
instrument. Each time an update file is released it will be made available on the website:
http://www.viscountinstruments.com. Update files are named L70S-XXX.L7U, where XXX stands for the update
version. After the file has been downloaded, copy it to the main folder (root) of a USB flash drive.
To check the currently running operating system version, access the UTILITY page under the System menu and
select the Release field:
To update the operating system, follow this procedure:
1.
Save the update file to a USB flash drive, then connect the drive to the USB [TO DEVICE] connector.
2.
Open the above mentioned video page, then press the data entry dial. The screen will show the name of the
update file found in the USB drive in the field "File":
3.
Make sure that this is the correct file, then press the data entry dial to start the update or press [EXIT] to
abort the operation. Once the update has started, the system checks the file integrity and shows the
message: ‚Checking udpate...‛. Then it loads the file, while showing the message: ‚Updating...‛ and the
progress percentage. When the operation is over the message ‚Update successful [Turn on/off]‛.
Legend '70s – User Manual
EN - 60