Driving Data - Seat Ateca 2016 Owner's Manual

Driving data

Memory
The MFD (multifunction display) shows differ-
ent values for the journey and the consump-
tion.
Changing between display modes on the
MFD
● In vehicles without multifunction steering
wheel: Press the rocker switch
›››
windscreen wiper lever Fig. 42.
Vehicles with a multifunction steering
●
›››
wheel: turn the thumbwheel
Multifunction display memory
The multifunction display is equipped with
three memories that work automatically: MFD
from departure, MFD from refuelling and MFD
total calculation. On the screen display, you
can read which memory is currently dis-
played.
● Toggle between memories with the ignition
on and the memory displayed: Press the
button on the windscreen wiper lever

or the button of the multifunction steering

wheel.
Menu
MFD from
departure
on the

MFD from
refuelling
Fig. 43.
MFD total
calcula-
tion
a)
It varies according to the instrument panel version.
Erasing a memory manually
● Select the memory that you wish to erase.
● Hold the

steering wheel or the
function wheel pressed down for about 2 sec-
onds.
The essentials
Function
Display and storage of the values for
the journey and the consumption from
when the ignition is switched on to
when it is switched off.
If the journey is continued in less than
2 hours after the ignition is switched
off, the new data is added to the data
already stored in the memory. The
memory will automatically be deleted if
the journey is interrupted for more than
2 hours.
Display and storage of the values for
the journey and the consumption. By
refuelling, the memory will be erased
automatically.
The memory records the values for a
specific number of partial trips, up to a
total of 19 hours and 59 minutes or 99
hours and 59 minutes, or 1999.9 km or
9999 km, depending on the model of
instrument panel. On reaching either of
a)
these limits , the memory is automati-
cally erased and starts to count from 0
again.
button of the multifunction
button of the multi-

Personalising the displays
In the Easy Connect system you can adjust
which of the possible displays of the MFD can
be shown on the instrument panel display
with the button and the function button

›››

page 108.
Setup
Data summary
Menu Function
The current fuel consumption dis-
play operates throughout the jour-
Current fuel
ney, in litres/100 km; and with the
consumption
engine running and the vehicle
stopped, in litres/hour.
After turning on the ignition, aver-
age fuel consumption in li-
tres/100 km will be displayed after
travelling about 100 metres. Other-
Average fuel
wise horizontal lines are displayed.
consumption
The value shown is updated approxi-
mately every 5 seconds.
®
ACT *: Depending on the equip-
ment, number of active cylinders.
Approximate distance in km that can
still be travelled with the fuel re-
maining in the tank, assuming the
Operating
same style of driving is maintained.
range
This is calculated using the current
fuel consumption.
This indicates the hours (h) and mi-
Travelling
nutes (min) since the ignition was
time
switched on.
»
33