Driving Data - Seat LEON Owner's Manual

submenu
Assist systems
Assist
Function
systems
menu
Lane As- Switching the Lane Assist system on or off
›››
sist * page 168.
Switching the tiredness detection on or off
Tiredness
detection * (pause recommendation)

Driving data

Presets
The MFD (multifunction display) shows differ-
ent values for the journey and the consump-
tion.
Changing between display modes on the
MFD
● In vehicles without multifunction steering
wheel: Press the rocker switch
›››
windscreen wiper lever
Vehicles with a multifunction steering
●
wheel: turn the thumbwheel
Multifunction display memory
The multifunction display is equipped with
three memories that work automatically: MFD
from departure, MFD from refuelling, MFD to-
76
tal calculation. On the screen display, you
can read which memory is currently dis-
played.
To change between memories with the igni-
tion on and the memory shown, press the
button
or you can also change between memories
using the button
steering wheel.
›››
page 172.
Menu
MFD from
depar-
ture
MFD from
refuelling
on the

Fig. 87.
MFD total
›››
calcula-
Fig. 88.
tion
a) It varies according to the type of instrument panel fitted.
Operation
on the windscreen wiper lever

on the multifunction

Function
Display and storage of the values for the
journey and the consumption from when the
ignition is switched on to when it is switch-
ed off.
If the journey is continued in less than 2
hours after the ignition is switched off, the
new data is added to the data already stor-
ed in the memory. The memory will auto-
matically be deleted if the journey is inter-
rupted for more than 2 hours.
Display and storage of the values for the
journey and the consumption. By refuelling,
the memory will be erased automatically.
The memory records the values for a specif-
ic number of partial trips, up to a total of 19
hours and 59 minutes or 99 hours and 59
minutes, or 1999.9 km or 9999 km, de-
pending on the model of instrument panel.
a)
On reaching either of these limits , the
memory is automatically erased and starts
to count from 0 again.
Erasing a memory manually
Select the memory that you wish to erase.
●
● Hold the button of the multifunction

steering wheel or the button of the multi-

function wheel pressed down for about 2 sec-
onds.
Personalising the displays
In the Easy Connect system you can adjust
which of the possible displays of the MFD can
be shown on the instrument panel display
with the button and the function button

›››
page 81.
Setup
Data summary
Menu Function
The current fuel consumption display
operates throughout the journey, in li-
Current fuel
tres/100 km; and with the engine run-
consumption
ning and the vehicle stopped, in li-
tres/hour.
After turning on the ignition, average
fuel consumption in litres/100 km will
be displayed after travelling about 100
Average fuel metres. Otherwise horizontal lines are
a) displayed. The value shown is updated
consumption
approximately every 5 seconds.
ACT ®
*: Depending on the equipment,
number of active cylinders.