Applying An Ip Policy; Ethernet Ip Policies - ZyXEL Communications Prestige 643 User Manual

FIELD
Len Comp
Precedence
Source:
Addr start= / end=
Port start= / end=
Destination:
Addr start= / end=
Port start= / end=
Action=
Gateway addr
Log
Type of Service
Precedence

13.2 Applying an IP Policy

This section shows you where to apply the IP Policies after you design them.

13.2.1 Ethernet IP Policies

From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -General Ethernet Setup.
You can choose up to four IP Policy sets (from twelve) by entering their numbers separated by commas,
e.g., 2, 4, 7, 9.
IP Policy Routing
SPACE BAR
Press [ ] to choose from Equal, Not Equal, Less, Greater, Less
or Equal or Greater or Equal.
Precedence value of the incoming packet. Choices are 1, 2, 3, 4, 5, 6, 7 or
Don't Care.
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Choose whether action should be taken on criteria Matched or Not Matched.
Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it's on the LAN, otherwise, the gateway must be the IP
address of a remote node. The default gateway is specified as 0.0.0.0.
Choose Yes to make an entry in the system log when a policy is executed.
Set the new TOS value of the outgoing packet. Choices are No Change,
Normal, Min Delay, Max Thruput or Max Reliable.
Set the new precedence value of the outgoing packet. Choices are 1, 2, 3, 4, 5,
6, 7 or Don't Care.
Prestige 643 ADSL Router
DESCRIPTION
13-5