Add Or Edit Static Route - ZyXEL Communications VMG Series User Manual

Figure 142 Network Setting > Routing > Static Route
The following table describes the labels in this screen.
Table 67 Network Setting > Routing > Static Route
LABEL
Add New Static
Route
#
Status
Name
Destination IP
Subnet Mask/
Prefix Length
Gateway
Interface
Modify

11.2.1 Add or Edit Static Route

Use this screen to add or edit a static route. Click Add New Static Route in the Static Route screen, the
following screen appears. Configure the required information for a static route.
Note: The Gateway IP Address must be within the range of the selected interface in Use
Interface.
Chapter 11 Routing
DESCRIPTION
Click this to set up a new static route on the Zyxel Device.
This is the number of an individual static route.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This is the name of the static route.
This parameter specifies the IP network address of the final destination. Routing is always based
on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
This is the WAN interface through which the traffic is routed.
Click the Edit icon to go to the screen where you can set up a static route on the Zyxel Device.
Click the Delete icon to remove a static route from the Zyxel Device.
VMG/EMG/AM/DM/GM Series User's Guide
268