Vortex Assembly Instructions - Oneida Air Systems Dust Cobra Owner's Manual

Vortex Assembly Instructions

Remove cardboard ring from Vortex Barrel
19
(S2) Inlet; you may need pliers to do so.
read a Whiz-Lock Nut (S4D) onto each
20
readed Rod (S4C), at side down, until it
is about 1" deep. [FIG. 20a]
readed Rod (S4C) into the threaded inserts
on top of the Vortex Barrel (S2) so that the at
side of the Whiz-Lock Nut is ush with the
Barrel. Finger tighten the rod and then use a
wrench to rmly tighten the Whiz-Lock Nut
down to the Barrel [FIG. 20b].
Note: Do not over-tighten the nuts.
are only meant to keep the rod from unscrewing
during use.
Place the HEPA Filter (S1) over the
21
Rods (S4C) with the gasket side facing down
[FIG. 21a].
e Rods should pass through the holes in the
tabs of the bottom of the Filter and through
the holes in the top of the Filter and the Filter
should align snugly with the top of the Vortex
Barrel [FIG. 21b].
Install the Rubber Spacer (S4B) onto the top
22
of each readed Rod (S4C), with the at side
facing up and the tapered side facing down
[FIG. 22a].
read the umb Nut (S4A) onto the top of
each readed Rod (S4C), tightening rmly
against the Rubber Spacer (S4B) below it [FIG.
22b].
en screw each
ese nuts
readed
S2
FIG. 19
S4C
S4D
1"
FIG. 20a
FIG. 21a
FIG. 22a
FIG. 20b
FIG. 21b
FIG. 22b
oneida-air.com 19