Oneida Air Systems Dust Cobra Owner's Manual page 18

Assembly Instructions (Continued)
Carefully install the GORE® CleanStream Pro
11
HEPA Filter (C) onto the ring and then slip
lter retainer strap (F18) to secure. [FIG 11]
Note: It is VERY important that the strap be
tight enough to hold the lter snugly in place
yet not so tight as to pull down and damage the
lter. Be careful not to crush the ame arrestor
mesh.
THE FAN BLOWER ASSEMBLY IS HEAVY AND CUMBERSOME. BE SURE TO HAVE ADEQUATE
HELP WHEN LIFTING!
Align the two retaining studs on the bottom of
12
the Motor Assembly (A) with the two notches
on the Cone Assembly (B) [FIG 12a] and
fasten these components together with Draw
Latches (F24) on either side. [FIG 12b.]
Note: Clean, HEPA ltered air will exit from the
Motor Assembly during operation to aid with
heat dissipation.
Insert a Drum Liner Bag (F41) into the Drum
13
(D), making sure it fully expands against the
sides and the bottom of the Drum.
edges of the bag should fold out and over the
Drum's upper rim [FIG. 13].
16 Oneida Air Systems
Retaining
Stud
FIG. 12a
e top
FIG. 11
Retaining
Stud
FIG. 12b
FIG. 13